It works!

This is basically the same as version 0.4.0 with the following changes:

• the silkscreen build instructions are now correct
• the OLED I2C resistor closest to the OLED header has been moved to the right a bit to make some more space for the resistor bodies.

Disclaimer: At the time of writing, I haven't actually manufactured this version. However as it's essentially identical to 0.4.0, which I have made, I have very high confidence in the design.

Generating 3 separate PCBs

JLCPCB weren't happy with all the small bridging sections in my heavily cut-out PCB so I've swapped to creating one PCB per layer of the sandwich case.

I've had this design manufactured and it works. Just note that the instructions on the silkscreen are wrong so use the build guide if you choose to make this version.

Switch cutouts are 14mm now

0.3.0

make switchplate cutouts 14mm so switches will fit

0.2.0

Supports for snap-off sections need to be >3mm to pass JLCPCB checks.

First release

At the time of writing, I don't know if this design works. About to send it to manufacture.