Inertial Measurement Unit (IMU) Driver based on on the MPU6050
This module is able to communicate to the MPU6050 throught I2C. The hardware support is very wide since the code is using Adafruit-Blinka and adafruit-circuitpython-busdevice that provides neccesary configuration for different platform, as shown in the following list:
- FEATHER_HUZZAH
- NODEMCU
- any_raspberry_pi_40_pin
- any_raspberry_pi_cm
- RASPBERRY_PI_A or RASPBERRY_PI_B_REV1
- RASPBERRY_PI_B_REV2
- BEAGLEBONE_BLACK
- BEAGLEBONE_GREEN
- BEAGLEBONE_BLACK_INDUSTRIAL
- BEAGLEBONE_GREEN_WIRELESS
- BEAGLEBONE_BLACK_WIRELESS
- BEAGLEBONE_POCKETBEAGLE
- ORANGE_PI_PC
- ORANGE_PI_R1
- ORANGE_PI_ZERO
- ORANGE_PI_ONE
- ORANGE_PI_PC_PLUS
- ORANGE_PI_PC_PLUS
- ORANGE_PI_PC_PLUS
- ORANGE_PI_PC_PLUS
- ORANGE_PI_PC_PLUS
- ORANGE_PI_PC_PLUS
- ORANGE_PI_PC_PLUS
- ORANGE_PI_PC_PLUS
- ORANGE_PI_LITE
- ORANGE_PI_PLUS_2E
- GIANT_BOARD
- JETSON_TX1
- JETSON_TX2
- JETSON_XAVIER
- JETSON_NANO
- JETSON_NX
- ODROID_C2
- ODROID_N2
- DRAGONBOARD_410C
- BINHO_NOVA
- MICROCHIP_MCP2221
- SIFIVE_UNLEASHED
- PINE64
This driver depends on:
"Adafruit-Blinka" "adafruit-circuitpython-busdevice" "adafruit-circuitpython-register"
The Hardware is the MPU6050
On supported GNU/Linux systems like the RRaspberry pi, Beaglebone, Jetson Boards, etc. you can install the driver locally from PyPI. To install for current user:
pip3 install py-imu-mpu6050To install system-wide (this may be required in some cases):
sudo pip3 install py-imu-mpu6050To install in a virtual environment in your current project:
mkdir project-folder-name
cd project-folder-name
python3 -m venv .env
source .env/bin/activate
pip3 install py-imu-mpu6050See:
- examples/MPU6050_SimpleRead_test.py for a simple read demo.
- examples/MPU6050_CSV_IMU_test.py for a writing IMU data into a csv file.
Contributions are welcome! Please read our Code of Conduct before contributing to help this project stay welcoming.
Add support to the magnetometer I2C device that can be connected at AUX_SCL and AUX_SDA pins