Funnels
Funnels can be generated using the hose connector modules. The funnels.scad was added to make this simpler to work with, but its just an abstraction on the hose connector modules.
| Property | Description |
|---|---|
| OpeningDiameter | funnel opening diameter |
| HangingHoleDiameter | Size of the hole for hanging |
| FunnelLength | Length of the main funnel section. Default is the difference of opening and tip, to five 45deg walls for easy printing. |
| WallThickness | Thickness of the funnel walls |
| Property | Description |
|---|---|
| SpoutAngle | Angle of the spout |
| TransitionStyle | Where should the angle be applied |
| SpoutXOffset | Offset the spout in the x direction |
| SpoutYOffset | Offset the spout in the y direction |
| Property | Description |
|---|---|
| SpoutTipDiameter | Internal Diameter of the spout tip |
| SpoutTipLength | Length of the spout tip. Default is related to funnel length |
| SpoutTipWallThickness | Wall thickness of the spout tip |
| Property | Description |
|---|---|
| SpoutLength | Pre tip length of the spout |
| SpoutDiameter | Pre tip internal diameter of the spout. |
There three sample settings in the Customizer.
A standard funnel, 40mm opening, 5mm spout
Funnel with an offset spout, 40mm opening, 5mm spout
Funnel with an angled offset spout, 40mm opening, 5mm spout
