iGate Configuration
This page contains iGate Mode configurations. You must update the Callsign, Wi-Fi and APRS-IS settings and may keep the other options as they are.
IMPORTANT: Don't forget to click on the "Update" button after making any changes to the options.
Callsign: Your callsign with SSID
Use GPS if Possible: Enable this option if you want to use GPS location for your iGate
GPS Timeout: If GPS is enabled but can not acquire a GPS fix, following latitude and longitude values used after this timeout (seconds).
Latitude: Use Decimal Degrees (Google Maps format), for example: 33.816
Longitude: Use Decimal Degrees (Google Maps format), for example: -111.736
If you need a GPS Coordinate Converter, try this one: https://boulter.com/gps/
Weather Station: APRS Weather station mode is enabled using on board temperature and humidity sensor.
Repeat APRS Messages Only: If this option is enabled, iGate repeat every packet which contains message data type identifier as follows:
Repeat All Packets If APRS-IS Connection Lost: If this option is enabled and internet connection is lost, iGate run as full digipeater mode and repeat all packets, not only message packets.
Active: Enable APRS-IS Connection
Passcode: APRS-IS passcode generated with your Callsign
Auto Server: Enable auto APRS-IS server selection based on your location.
Server: APRS-IS server used if auto server is not enabled.
Port: 14580
Filter: use your preferred filter or leave blank