Setup (Configuration) Mode

1. Put Your Device in Setup Mode

To access the setup menu, first, put your device in setup mode. You can do this by resetting your device using the "RESET" button or by powering it off and on again. Upon startup (within 7 seconds), press the "BOOT" button three times. This action will put your device in setup mode, and you will see Access Point information on the OLED display if connected.

2. Connect to Your Device's Wi-Fi Access Point:

Connect your computer to the following Access Point listed in your computer's Wi-Fi settings:

SSID: LightLoRa_XXXXX_V1.X.X

Password: Light12345

After connecting, type the following URL into your browser's address bar (preferably Chrome if possible) and press enter:

URL: http://192.168.4.1