New features

New Features

• Detect more errors and warnings
• Turn off the finished state if the door is opened after the print finishes
• Setting finished idle timeout to 0 will leave the device in the finished state until the door is opened (if you print with the door open, you can just close it and open it again to exit the finished state)

Bug Fixes

None

Installation

Use a Web Browser to install the firmware and configure the WiFi for the latest version here.

Alternatively you can install these binaries using the Adafruit Web Tools:

• Go the the Adafruit Web Tools page.
• Set the the baud rate to 921600
• Use the table below to upload the files. The web tools page only allows you to upload 4 files at once. Do the first four first, then the last one:

Binary	Location
bootloader.bin	0x1000
partitions.bin	0x8000
boot_app0.bin	0xe000
firmware.bin	0x10000
littlefs.bin	0x290000

Initial release

Initial release. See the readme for details.

You can install these binaries using the Adafruit Web Tools:

• Go the the Adafruit Web Tools page.
• Set the the baud rate to 921600
• Use the table below to upload the files. The web tools page only allows you to upload 4 files at once. Do the first four first, then the last one:

Binary	Location
bootloader.bin	0x1000
partitions.bin	0x8000
boot_app0.bin	0xe000
firmware.bin	0x10000
littlefs.bin	0x290000