Board: MSB 430H
| MCU | TI MSP430F1612 |
|---|---|
| Family | MSP430 |
| Vendor | Texas Instruments |
| Package | 64 QFN |
| RAM | 5Kb |
| Flash | 55Kb |
| Frequency | 8MHz |
| FPU | no |
| Timers | 2 (2x 16bit) |
| ADCs | 1x 8 channel 12-bit |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 1 |
| Vcc | 2.0V - 3.6V |
| Datasheet / Reference Manual | Datasheet |
| User Guide | User Guide |
| RF Chip | Texas Instruments® CC1100 |
|---|---|
| Frequency Band | 300-348MHz, 400-464 MHz, and 800-928 MHz |
| Standard compliance | DASH7 compliant |
| Receive Sensitivity | -94dBm typ |
| Transfer Rate | 500kBaud |
| RF Power | -30dBm ~ 10dBm |
| Current Draw | RX: 14.4mA TX: 16.9mA Sleep mode: 400nA |
| RF Power Supply | 2.1V ~ 3.6V |
| Antenna | Dipole Antenna / PCB Antenna |
| Datasheet | Datasheet |
Flashing RIOT on the MSB-430H is quite straight forward, just connect your board using a JTAG adapter (either the original one from TI or an Olimex version) to your host computer and type:
make flash
This should take care of everything!
The shell is using the UART interface of the MSB-430H at 115200 baud. You need a 3.3V TTL serial cable. For USB connections you could use a FTDI connector