Skip to content

ESP-BOX Release V0.2.1
Compare
Choose a tag to compare
@Real-YuZhe Real-YuZhe released this 01 Dec 09:15
· 214 commits to master since this release
v0.2.1
1876da2

ESP-BOX v0.2.1 has bug fixes and performance improvements to the previous ESP32-S3-BOX development board firmware. Include the following:

  • Update the animation of the speech recognition interface to improve response speed and fluency

  • Fixed the issue that the voice wake-up animation was extremely stuck when the prompt message was not closed

  • Fixed the problem that the control panel information was not synchronized after the LED status was modified by voice

  • Fixed the problem that the LED does not turn on when the brightness is updated through the Web

  • Updated LVGL to V8.1

    • Dark lines appear in the shadow of the control in V8.0 : LED with custom style

    • All third-party components are moved to the LVGL epository. Remove all lv_lib_xxx and ntrol whether the component is enabled through Kconfig.

    • Split file system support to stdio, POSIX and FatFS. Select stdio according to IDF support and specify the default drive letter in CMakeLists.txt

  • Fixed an issue where a command word that was too short was added successfully on the web page but esp-sr refused to add it

In addition, update the factory firmware version number to V0.2.1.

Update and Flash Firmware

To flash firmware under Windows system, please to the Firmware update for Windows

To flash firmware under Linux system, please to the Firmware update for Linux

To flash firmware under macOS system, please to the Firmware update for macOS

Troubleshooting

  • Program upload failure

    • Hardware connection is not correct: run idf.py -p PORT monitor, and reboot your board to see if there are any output logs.
    • Try to put ESP32-S3 into download mode. To do this, keep GPIO0 low while toggling reset. On many development boards, the “Boot” button is connected to GPIO0, and you can press “Reset” button while holding “Boot”.

  • LCD does not display properly or flickers

    • Make sure that the MUTE button is not pressed, and the yellow indicator light on the top of the development board is not lit.
    • If there is still no response, reset the device or reconnect the USB-C cable.

  • No response after scanning the QR code

    • Try to manually connect to the AP displayed on the screen and enter the URL in the browser.
Assets 4
Loading