An open source arduino based firmware for esp32. Compiled with arduino ide with esp32 core 2.0.5.
Beat detection is made by using code from Damian Peckett https://create.arduino.cc/projecthub/mamifero/arduino-beat-detector-d0a21f
Light controller is using 12 gpio outputs or 1-12 lights can be connected to it. Number of outputs can be easily extended just add gpio pins to the array pin_num[], pin_name[] & pin_func[] in light.ino.
The outputs or lights can flash to the beat of the music or they can be programmed into one of the 8 flashing programs. The flashing program can be triggered by a beat of music, a time interval or an http call. The state of each output can be set as: ON, OFF, PROGRAM, RAND SPD, BEAT or HTTP (see screenshots below).
-
ON output stays in HIGH state
-
OFF output stays in LOW state
-
RAND SPD output is randomly flashing according to the selected rate of slider setting
-
PROGRAM output is flashing according to the selected program P1 to P8
-
BEAT output is flashing to the beat of the music
-
HTTP output is flashing on http call (http://ip_address/trigger)
-
BEAT programs are triggered by beat of music
-
TIMER programs are triggered by time interval, speed is setted with this slider
-
HTTP programs are triggered on http call (http://ip_address/trigger)
-
Slider RAND SPD speed of random blinking for individual output
-
Slider BEAT TRESHOLD setting for level of music beat detection
-
Slider BEAT TRANDLY pulse length adjustment for the program when beat of music is detected
light.mp4
Music from Paul Kalkbrenner - Live at Tomorrowland 2022 (https://www.youtube.com/watch?v=fa2N9OBK8v4)
Flashing the firmware ESP32 Flash Tool
Download light_v1_esp32.bin and flash :)
After flashing esp will turn on soft AP with ssid light and psk password. Default creds for settings are user admin and pass password.
(http://IP_address/)
settings (http://IP_address/settings)
Use websockets with async http server and polish web gui. Remove timezone, CSS and syslog from settings, not needed...