Skip to content

Home

Jump to bottom
Changgang Li edited this page Feb 8, 2021 · 20 revisions

Welcome to the STEPS wiki! I will post usage of STEPS in the wiki step by step. Hope it can serve as temporary documentation before the real documentation is available.

  1. How to build STEPS kernel
  2. How to build STEPS kernel
  3. How to install stepspy in Python
  4. Brief introduction to stepspy APIs
  5. How to create a simulator

If you find something like simulator.xxx, it is assumed that the simulator is a STEPS simulator created in How to create a simulator

  1. How to configure device capacity IMPORTANT
  2. How to set up allowed maximum bus number
  3. How to add or remove devices
  4. Examples

Cite STEPS via: Changgang Li, Yue Wu, Hengxu Zhang, Hua Ye, Yutian Liu and Yilu Liu, "STEPS: A Portable Numerical Simulation Toolkit for Electrical Power System Dynamic Studies," in IEEE Transactions on Power Systems, doi: 10.1109/TPWRS.2020.3045102.

  1. How to build STEPS kernel
  2. How to build STEPS kernel
  3. How to install stepspy in Python
  4. Brief introduction to stepspy APIs
  5. How to create a simulator
  6. How to configure device capacity\
  7. How to set up allowed maximum bus number
  8. How to add or remove devices
  9. Examples
Clone this wiki locally