MinimOSD made smaller with better pinout and USB.
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
After assembly, review the Firmware notes for loading software.
There are four jumpers that are useful for configuration.
Two are sets of three pads labeled 12-5. The one closest to the
IN pad sets the camera voltage. Shorting the two pads on the 12
side sends 12V to the camera, and the two closest to the 5 side
sends 5V to the camera. The one nearest the OUT pad is the same for
the VTX.
On the same side, there's an GND jumper which configures a common
ground for the OSD itself and the video.
On the other side, there's one labeled +V which jumps the 5V input
pins so you can have a single 5V input that is used for both outputs
and operating the OSD itself.
- D1, D2, D3 - 3x 0603 LED
- D5 - 0805 Schottky
- IC4 - MAX7456EUI+
- U1 - Atmega 328P AU
- U2 - 0603 1k Resistor Array OR digikey
- U9 - CP2102
- C1, C2, C3, C4, C5, C6, C17, C19 - 0603 0.1μF
- R1, R14 - 0603 10kΩ
- Y1 - 16MHz resonator
- R2, R3 - 0603 75Ω
- C18 - 1μF cap
- Q1 - 27MHz resonator OR digikey
- C7, C8 - 0603 4.7μF tantalum cap
- J1 - USB micro B or digikey
