Since update, Bookbuilder doesn't do anything anymore

[xdemiansmithx]

Hello,
I initially installed BookBuilder a couple of months ago and yesterday "updated" it by removing and cloning again.
After installing the requirements and putting back my config.yaml, Bookbuilder doesn't do anything anymore. If i run
python3 BookBuilder.py it takes about one second, then goes back to command prompt without any output.

I will attach my config, in case that helps.
config.md

Any insight will be appreciated 👋🏻

[biplab37]

I think the new update added gui features and deprecated earlier method of adding config. Instead use
python3 main.py to launch a window where you can set parameters (rather than in the file config.yaml).

[xdemiansmithx]

thank you! main.py was the only .py i didn't try 🙈. Now to figure out how to save the configuration 🤔