Set Storage and Transfer from the command line and the port?

[black-jmyntrn]

for the life of me, i can't find the file to edit so I can change the port and actual storage and transfer drives. am i missing that in some instructions out there?

[outdoorbits]

What are you looking for? Lbb ist managed and configured by it's web UI.

[black-jmyntrn]

really to change the port to something other than 8000

[outdoorbits]

What's about using Https and port 443?

[black-jmyntrn]

The problem is I want to run Bitfocus Companion at the same time and it needs to use both 8000 and 443, I want to change LBB ports. Is that not possible?

[outdoorbits]

You can edit apache_ports.py and replace 8000 by whatever you want. This works of you use Comitup. Else just edit /etc/apache2/ports.conf.
Then you have to edit /etc/apache2/sites-available/little-backup-box.conf and do the same.
... and reboot.

[black-jmyntrn]

oh my wow! thank you! I did find the apache_ports file and made changes a few days ago but couldn't figure out why they didn't stick!

[black-jmyntrn]

what about setting the target and source permanetly? I am using the Siig JU-SA0S12-S1 USB 3.0 to SATA Hard Drive with SD Reader with a SATA NVME drive as my target but for some reason, every time I insert a SD card, it wants to sync to the SD card and the TARGET drive gets unset... even after update with the new drop downs under modifications.

I also have a stream deck on this LLB running companion through the VENTION USB Hub

[outdoorbits]

You are running a usb to usb backup, right? Do you connect both drivers before starting the backup? If yes, please try the following: - Disconnect your source, target can stay connected - start backup - check your display or the log monitor and wait until target is mounted and until you are asked to connect source Does this solve the problem?

[black-jmyntrn]

unfortunately, it does not and I always start it with the source only then insert the target.

[outdoorbits]

Could you please send your log file? Please set log to maximum.