Create a basic proof-of-principle 3D printed shoe

[TheOtherRealm]

• Just Printed right shoe
• Took over 3 days
• Used a Sovol SV04 duel extruder with Shoe A 88 TPU
• The upper is too thin (note the duct tape that I needed to put between the eyelets so that the laces did not rip. It feels like a galosh.
• The widened lateral outsole significantly improves stability to the point of being able to run without the foot rolling over
• However, the eversion in the insole is way too aggressive and the arch way too low, resulting in knee pain
• There is not enough bounce
• These two previous problems can be mitigated to some degree using a slide-in insole
• Due to the limitations in the 3D printer, there is no tread and the outsole is flat, resulting in a clomping feeling when running