Results of first stage: edge model

[Emy-cv]

Thank you very much for your codes.
I have trained the edge model for 2000,000 iterations, and get the following results

From my training, the model didn't generate satisfying edges.
I tested the pre-trained model posted by you, and it can generate better results as follows,

Any idea where I am wrong? I didn't change the code.
Thank you so much for your time.

[ewwnage]

I encountered the same behavior

[01SHENyankun]

我遇到了同样的行为

你好，不知你是否复现出来了，如果复现出来了，求指导。qq2635505974

[01SHENyankun]

非常感谢您的代码。 我已经为边缘模型训练了 2000,000 次迭代，并得到以下结果 从我的训练中，模型没有生成令人满意的边缘。 我测试了你发布的预训练模型，它可以产生更好的结果，如下所示， 知道我错在哪里了吗？我没有更改代码。 非常感谢您的参与。

你好，不知道你是否已经复现出来了，如果复现出来了，求指导。qq2635505974

[zhangxiao121]

我遇到了同样的行为

你好，不知你是否复现出来了，如果复现出来了，求指导。qq2635505974
你好，请问你复现出来了吗？

[TT-mouse]

@Emy-cv Thank you for your training feedback.
I also met a similar problem during training. If you see my reply, can you tell me what caused it?
Thank you very much!

[Ghost0405]

Hello, I also encountered this problem, did you solve it?

[danielanojan]

I am raising the question which has been raised multiple times before but I could into find a solution

I tried to train edge model but it not converging however the inpainting model training works.

I would appreciate if anyone can guide me to any other code to generate canny edges for masked regions similar to whats described in in this code
Thank You