Pringles, will do the job - no 3D Printer needed #2523
wrybit
started this conversation in
Show and tell
Replies: 0 comments
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hey.
If you dont own or know some one with a 3D Printer, just like me .. than just used a Pringels can,
some Gaffa tape, a cable tie and Masking Tape (Keppband) and you will be good to go.
Fits perfectly, had nearly no cost and you had something to snack while the configuration ;)
Done. ~5min.
Put the can on the water meter. Should fit fairly snugly. (At least in my case).
If not, pack some door sealing tape (5mm self adhesive) in between.
That way you can take it off but it holds well.
And via the plastic lid you could still see the meter the classical way ;)
Greez Jens
Beta Was this translation helpful? Give feedback.
All reactions