Board: Phytec phyWAVE KW22
Designed and produced by PHYTEC Messtechnik GmbH, D-55129 Mainz.
Homepage | Ordering information via mail at [email protected]
The Phytec IoT wiki describes the phyWAVE module and the phyNODE board more detailed. The links below will guide you directly to the corresponding chapter:
- Overview
- Introduction
- Hardware Description
- Toolchain, build and debug Information
- A detailed step-by-step Guide that explains how to set up the Environment
The implementation status of the phyWAVE and phyNODE peripherals are listed below. You can find links to the corresponding Pull Requests which may give you a code reference.
phyNODE board with equipped phyWAVE-KW2x processor/radio-module.
The PCB-pieces with the mounted sensors can be separated from the evaluation board to capture sensor values from specific spatial points.
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | MKW22D512 | yes | mainline |
| phyWAVE board support | phyWAVE | yes | mainline |
| Low-level driver | GPIO | yes | mainline |
| PWM | yes | mainline | |
| UART | yes | mainline | |
| I2C | yes | mainline | |
| SPI | yes | mainline | |
| USB-Device | yes | WIP | |
| RTT | yes | mainline | |
| RNG | yes | mainline | |
| Timer | yes | mainline | |
| Radio Chip | integrated | yes | mainline |
| Humidity Sensor | HDC1000 | yes | mainline |
| Pressure Sensor | MPL3115A2 | yes | mainline |
| Tri-axis Accelerometer | MMA8652FC | yes | mainline |
| Magnetometer | MAG3110FCR1 | yes | mainline |
| Light Sensor | TCS3772 | yes | mainline |
| IR-Termopile Sensor | TMP006 | yes | mainline |
| Capacitive Button | PCB | no | planned |