You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello...I have three drivers, three axes, and a standalone DC Motor for a spindle.
For some reason with these DM332T drivers, I cannot make motor movement. I have posted on here before this time looking for advice.
I just downloaded the newer firmware and I will be installing it soon. Anyway...
The drivers have this pin called OPTO. It needs 5v supplied to it. What pins from the T41U5XBB board with the teensy4.1 would I use to supply the 5v? Are there any pin mappings stating 5v output even with my 12v PSU?
Seth
P.S. Thank you in advance if you can make me understand.
The text was updated successfully, but these errors were encountered:
Hello...I have three drivers, three axes, and a standalone DC Motor for a spindle.
For some reason with these DM332T drivers, I cannot make motor movement. I have posted on here before this time looking for advice.
I just downloaded the newer firmware and I will be installing it soon. Anyway...
The drivers have this pin called
OPTO. It needs 5v supplied to it. What pins from theT41U5XBBboard with the teensy4.1 would I use to supply the 5v? Are there any pin mappings stating 5v output even with my 12v PSU?Seth
P.S. Thank you in advance if you can make me understand.
The text was updated successfully, but these errors were encountered: