Skip to content

Lantern Pi Instructions

Jump to bottom
atavism edited this page Feb 1, 2015 · 6 revisions

Lantern Pi Instructions

This guide offers instructions for setting up and connecting your new Raspberry-Pi powered Lantern.

  • Your Lantern goes perfect alongside your home router. Plug-in the ethernet cable (included with your kit) into an available port on your router.
  • Connect the power supply. You should see your device power on. After the boot processes finishes, the Lantern application will immediately start running.
  • Open your current instance of Lantern on a home computer that's connected to the same local network. If you do not have Lantern installed already, you can download it from here: https://getlantern.org
  • Once you have Lantern open, use the UI to pull up the Settings modal (it's accessible from a small gear icon in the lower right part of the UI screen). This window contains a "Local Lanterns" section, and the address for your Lantern should appear there as a clickable link. This will open the UI (a real-time world map) with statistics about your Lantern and the overall network. From here, you can adjust settings as you ordinarily would from your current instance.
  • To make sure your Lantern is able to proxy traffic (and you will know this is happening if the brightness of the light changes), you need a router with NAT-PMP or UPnP enabled, which automates the process of port forwarding. Another option is to manually map external port 443 to internal port 44377. Consult your router manual for more information.

Troubleshooting

  • If it does not appear there, and you are familiar with a shell, you can use nmap to locate the device:
nmap -sn 192.168.1.0/24
Clone this wiki locally