Allow Feedrate to start with 20% ( instead of 50% )

[Uwe-Kaki]

Hi, would it be possible ( technically it would for sure ) to let the setting for the feedrate to start with 20% instead of 50% ?

Background :
I have set the feedrate in all my Cura Profiles to 100mm/sec, therefore the percentage on the printer display ( FR in Ender 5 ) matches exactly the speed in mm / sec.
I don't have to think or even check the profile to know how much 50% actually is with the current print

my current "workflow" is to start every print manually with 20 mm/sec - 30 mm/sec to get the best first few levels and then increase to the desired speed. Many times I use octopod to check the print progress.

unfortunatly OctPod does allow only to start with 50%, even if I type in "20%" it accepts that, but actually configures the printer to run with 50% at the minimum.

is there something I missed, so that would no be a useful idea ?

thx for reading

Uwe