Cannot control circulation pump from HA

[ec0li82]

Hello,
In HA my circulation pump is detected as a sensor AND as a waterfall switch.
When it's running, both of these change on and off, as expected.
But if I try to turn it on manually (via the waterfall switch), the switch does not stay on...and nothing happens.
If I try to do the same manually via geckolib (command waterfall on), it works.

Device info:
inYT 677 v3.0
by Gecko Alliance
Firmware: SpaPack:v36.01 Config:82 Log:81
Hardware: EN:88 v15.0 CO:89 v11.0

[ec0li82]

update : works when using preset mode ON instead of switch

[thogens]

Hi!
can you elaborate a bit? What do you mean exactly? I have the same problem...
Thanks

[ec0li82]

Hi
I mean that clicking the waterfall fan switch does nothing.
But changing the preset changes it to on.
Small video :

Screen_Recording_20240720_210627_Home.Assistant.mp4

You can do that in an automation with : call a service; fan set preset mode

Note that doing that will turn on the circulation pump, but it turns off automatically after 2 hours.

[thogens]

Ok, understood and it works. Note that switching off again won't be possible until you wait 5mins or so. Just tried it, but ok. - That's fine.
Thanks!