Throttle not detected in UCR

[haider04]

Hi all,

I am using vJoy along with UCR to integrate my steering wheel and pedals to work as 1 single USB controller input (Currently i am having 2 USB inputs, 1 from Fanatec pedals (throttle and brake), and 1 from steering wheel (Leobodnar Forcefeedback SimSteering)). Both steering wheel and pedals are from different manufacturers, so there is no point of connecting them together.

I wanted to use vJoy because i am using AirSim (open-source simulation software from Microsoft) to control the car with my steering wheel and pedals but the problem is, AirSim detects only 1 control input. So when i connect both USb inputs, it only detects one, either steering wheel or pedals, whichever is on priority.

So i am using vJoy to make them working as a single control input. But my throttle is unfortunately not detected in UCR. Steering wheel and brake are detected and working fine. I wanted to ask what could be the problem that is causing my throttle not to be detected? Because throttle and brake are connected through same USB and only brake is detectable.

If someone can share some solution how my throttle could be detected, i would really appreciate that. I was spending quite a lot time over it but in vain.

Any solution, suggestions will be highly appreciated. Thanks!

Haider

[evilC]

Is this maybe related to #215 ?
Same question - does the new UCR-C# suffer from the same issue?
I would heavily recommend moving over to it if it does, as UCR-C#'s joystick input is way way better (No off-center midpoint like in UCR-AHK)