-
Notifications
You must be signed in to change notification settings - Fork 0
/
Makefile
76 lines (60 loc) · 2.5 KB
/
Makefile
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
# Copyright 2015 Erik Van Hamme
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
# -----------------------------------------------------------------------------
# Select target board by uncommenting the appropriate line.
# -----------------------------------------------------------------------------
#board := stm32f3discovery
board := stm32f4discovery
# -----------------------------------------------------------------------------
# Common settings.
# -----------------------------------------------------------------------------
project := ecppstm32demo
buildmode ?= release
module_dirs := . ecpp ecppstm32
# -----------------------------------------------------------------------------
# Settings for stm32f3discovery board.
# -----------------------------------------------------------------------------
ifeq ($(board),stm32f3discovery)
module_dirs += stm32f3
chip := stm32f303xc
defines += -Dstm32f3 -DSTM32F303xC
arch := -mcpu=cortex-m4 -mthumb -mfloat-abi=softfp -mfpu=fpv4-sp-d16
oocdcfgs := -f "interface/stlink-v2.cfg" -f "target/stm32f3x_stlink.cfg"
oocdcmds = -c "init" \
-c "reset halt" \
-c "flash erase_sector 0 0 4" \
-c "flash write_bank 0 $(binfile) 0" \
-c "reset run" \
-c "shutdown"
endif
# -----------------------------------------------------------------------------
# Settings for stm32f4discovery board.
# -----------------------------------------------------------------------------
ifeq ($(board),stm32f4discovery)
module_dirs += stm32f4
chip := stm32f407xx
defines += -Dstm32f4 -DSTM32F407xx
arch := -mcpu=cortex-m4 -mthumb -mfloat-abi=softfp -mfpu=fpv4-sp-d16
oocdcfgs := -f "interface/stlink-v2.cfg" -f "target/stm32f4x_stlink.cfg"
oocdcmds = -c "init" \
-c "reset halt" \
-c "flash erase_sector 0 0 1" \
-c "flash write_bank 0 $(binfile) 0" \
-c "reset run" \
-c "shutdown"
endif
# -----------------------------------------------------------------------------
# Import make rules.
# -----------------------------------------------------------------------------
include buildscripts/stm32project.mk