problem with z-home in printing from usb-b port

[ghost]

Hi Digant,

I have a sidewinder X1 with BlTouch Waggster Mod, I have installed the corresponding firmware here available in both TFT and marlin.
I run into a problem that frustrates me a lot, because I want to use your firmware with all my might:
If I laminate a model and export it in Gcode to a flash drive, I insert it into the USB port of the TFT and print everything perfectly...
If I laminate and send it to octoprint, or send it with CURA (4.13, 5 or 5.1) via USB to the USB-B 2.0 port of the printer when doing Home Axis X and Y are correct, but Z does not take out the BlTouch which means an accident against the bed. (I have to cut the power abruptly)

Do you know what could be causing this?
Thank you very much in advance

[digant73]

hi
No. If you are connected to the printer's USB port then it's only Marlin (and not the TFT) processing the gcodes.

[ghost]

hi No. If you are connected to the printer's USB port then it's only Marlin (and not the TFT) processing the gcodes.

ok, some marlin that recommends me to try along with their TFT firmware?

[ghost]

I just tried your marlin distributions, 2.0.8x and 2.0.9x have the same problem.in the previous ones there are several bltouch errors, I have reviewed the waggster wiring countless times.I don't understand what's going on