README_AP_SYSTEMS_ZIGBEE.md

Todos

• IEEE is hardcoded to 0xD8A3011B97xx
• Unable to change channel (use firmware with channel 16 as default)
• Encode polled data into values
• Allow to set ECU ID

Already included

• AP System profile and Endpoint registered
• IEEE adress set
• Excluded security stuff if firmware is without SECURE compiled

My Example Setup

• ECU ID: 0xD8A3FFFF823D0910
• Inverter ID: 0x3D82

Configurate Tasmota

• Build Tasmota with Zigbee and ZNP Support
• Connect CC2530 with ESP8266
  • VCC -> VCC
  • GND -> 3.3V
  • P02 -> D8
  • P03 -> D7
• Configurate the Module
  • Select Generic (0)
    • D7/GPIO13 = Zigbee RX
    • D8/GPIO15 = Zigbee TX
• Check if Zigbee is started, use Sniffer and click Zigbee Permit Join button for test
• Submit command via Web console (Pan ID are the first two IEEE bytes)

  ZbConfig {"Channel":16,"PanID":"0xA3D8","ExtPanID":"0xD8A3FFFF823D0910"}
  ZbReset 1 (required?)
  

Send to broadcast to all inverters

Submit command via Web console

ZbZNPSend 2401FFFF1414060000000F1E80971B01A3D8FBFB1100000D6030FBD3000000000000000004010281FEFE

Send request to inverter 0x3D82

Submit command via Web console

ZbZNPSend 2401823D1414060001000F1380971B01A3D8FBFB06BB000000000000C1FEFE

Rules

Use rules to poll the invertes every minute

Rule1 
  ON Time#Minute DO ZbZNPSend 2401823D1414060001000F1380971B01A3D8FBFB06BB000000000000C1FEFE ENDON
  
Rule1 1

or

Rule1 ON System#Boot DO RuleTimer1 20 ENDON ON Rules#Timer=1 DO backlog ZbQueryInverter 0x3d82; RuleTimer1 20 ENDON

Rule1 1