Sensor support installation

[WirthmU]

I wanted to install sensors. In the config section it is stated that "Hardware Device support requires the python GPIO modules". How would I do this? I could not find any help to this.

[aaronwmorris]

When you run setup.sh, it will prompt to optionally install the GPIO modules. If you have already done that, you should be good to go.

[aaronwmorris]

That seems to be working perfectly!

[WirthmU]

I agree, but what the MQTT host receives is not complete:

Sensor 16 should be "visible" and sensor 18 should be "full spectrum".

[aaronwmorris]

Looks like the visible data from TLS2591 is not making it.

[aaronwmorris]

I do not understand why it is coming through as the curly braces.

[aaronwmorris]

Testing with my TSL2591, I am receiving data properly.

$ mosquitto_sub -h localhost -p 1883 -u indi-allsky -P password -t indi-allsky/sensor_user_15 -t indi-allsky/sensor_user_16 -t indi-allsky/sensor_user_17 -t indi-allsky/sensor_user_18
1.7
327683.0
5.0
327688.0

[aaronwmorris]

Merged #1545 with LTR390 UV light sensor support. You will need to re-run setup.sh to install the new GPIO module for the sensor.

I do not have this sensor, so I am not able to test the code. Let me know if it works and I will mark it as "working".

[WirthmU]

It works and I get values.

After I did re-boot the host, the MQTT problem is solved, too.

Thank you for your support!