New model not working.

[Papa-Yankee]

Hello everyone.
I'm in a lot of trouble. I switched two weeks ago to Edge TX on my TX16S, since Open TX. The models present at the time of the switchover work perfectly well.
I'm now entering a new model (a Baron that I'm just finishing building). Being the slacker that I am, I foolishly duplicated an existing model. I changed the photo (fundamental!), and plugged in a receiver.
Everything seemed to be going well until I move the sticks. Randomly, the receiver's LED turns red, the servos lock in position, and I can't regain control until a variable delay has elapsed.
Edge advised me to update the firmware of the 4-in-1 module, which I did, but no change.
I tested with two different receivers (RX8R pro), same symptoms. I re-tested my trainer, which still works perfectly. I compared the two models under Companion, and I can't see any difference that might explain the phenomenon....
I also tried to create a model ex nihilo from the transmitter, but identical symptoms...
If anyone has any ideas, I'd love to hear them, because right now, I'm at a loss...

Thanks for reading.

[Papa-Yankee]

Problem solved. It was caused by a deficient power supply.

[pfeerick]

Glad to hear you solved it. Reading the symptoms again, it would probably have been that or servos that needed checking.

…

On Sat, 23 Mar 2024, 5:21 am Papa-Yankee, ***@***.***> wrote: Problem solved. It was caused by a deficient power supply. — Reply to this email directly, view it on GitHub <#4782 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABJ66KICMBV7XR5FBJPPJNTYZSAFPAVCNFSM6AAAAABFA2HW4CVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4DQOBSGAYTE> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>