diff --git a/docs/troubleshooting.md b/docs/troubleshooting.md
index 13e5030a..5df5baaf 100644
--- a/docs/troubleshooting.md
+++ b/docs/troubleshooting.md
@@ -59,7 +59,7 @@ Based on my own experiences, the following variables besides the retraction sett
 - The quality of filament.  
 - The moisture of filament: moist filament increases stringing.  
 - The printing temperature: too high as well as too low printing temperatures cause stringing.  
-- The [feeder gear pressure](hardware/printhead.md#extruder-feeder): if it's too low, the gear can't grab the filament reliably and therefore can't retract reliably.  
+- The [feeder gear pressure](hardware/printhead.md#extruder-feeder-gear-system): if it's too low, the gear can't grab the filament reliably and therefore can't retract reliably.  
 - The state of the feeder gear: if the teeth of the feeder gear which grabs the filament is kinda clogged due to debris of the filament, then it might slip as well.   
 - The quality and the state of the [nozzle](hardware/printhead.md#nozzle): low-quality nozzles as well as worn out and/or slightly clogged nozzles can increase stringing. Also the diameter of the nozzle has an impact as it determines how much filament gets extruded.   
 - The quality and the state of the PTFE tube inside of the heatbreak (Neo) or the bowden tube overall (Go).